Abstract:
SiC particle reinforced metal matrix composites (MMCs) were produced by a common liquid phase technique in two melting routes. In the first route, 5, 10, 15 and 20 vol% SiC reinforced A356-based MMCs were produced. In the second route, an Alcan A356 + 20 vol% SiC composite was diluted to obtain 5, 10, 15 and 20 vol% SiC MMCs. In both cases the average particle size was 12 mu m. The composites that produced by two different routes were aimed to compare the dry wear resistance properties. A dry ball-on disk wear test was carried out for both groups of MMCs and their matrix materials. The tests were performed against a WC ball, 4.6 mm in diameter, at room temperature and in laboratory air conditions with a relative humidity of 40-60%. Sliding speed was chosen as 0.4 m/s and normal loads of 1, 2, 3 and 5 N were employed. The sliding distance was kept at 1000 in. The wear damage on the specimens was evaluated via measurement of wear depth and diameter. A complete wear microstructural characterization was carried out via scanning electron microscopy. The wear behaviors were recorded nearly similar for both groups of composites. Diluted samples showed lower friction coefficient values compared with the friction coefficient values of the vortex-produced composites. This was attributed poor bonding between matrix and particles in the vortex-produced composites associated with high porosities. But, in general, diluted Alcan composites showed slightly lower wear rate relationship with the particle volume percent and applied load when compared with vortex produced materials. (C) 2005 Published by Elsevier Ltd.
